Remote
radians
@radians@poa.st
pleroma 2.10.2-442-gb68f13b9-developreformat, reinitializing, reboot.
53 Followers
137 Following
24 Posts
Joined May 13, 2026
Replying to
@skylar@misskey.yandere.love @EllisDee@wolfgirl.bar Maybe hardwood has been expensive for a while though.
Your other option is a $50 sheet of 3/4" MDF which is what I use for wood shop tops since its cheap enough to toss out when its too burned/dented/oily to work on anymore.
Replying to
>toweling off your woman because you're going to dick her hard
>instead its a world is fucking ending blam story.
Replying to
@skylar@misskey.yandere.love @merchantHelios@poa.st "tee hee im bad at this" is 98% of women and soulslikes with the other 2% actually being good and fun to watch.
Replying to
@deprecated_ii@poa.st @skylar@misskey.yandere.love also, where the 150psig comes from is that for most shop air systems the model code is ASME B31.9 Building Service Piping(and not 31.1 power piping), which limits covered steam/air systems to 150psig working pressure.
Replying to
@nugger@poa.st @deprecated_ii@poa.st it sounds cool right up until the time you have to service or replace one, same with solar setups that are difficult to access.
Replying to
@deprecated_ii@poa.st @skylar@misskey.yandere.love https://www.engineeringtoolbox.com/
handy bookmark for when you need a chart or formula calculator.
not all "black pipe" is A53 welded seamless. a lot of the big box stores sell inferior grades since the main use of steel pipe in residential is fuel piping at 15psi max.
Replying to
@wertimer@clubcyberia.co @skylar@misskey.yandere.love also if any of your runs are over 6 feet those need a ground conductor.
Replying to
@skylar@misskey.yandere.love For a benchtop i happened to look at lowes earlier and hardwood butcherblock kitchen countertop material 25x96 inches is $250 which would cover both of those cabinets with some left over.
Replying to on nekosat.work
Replying to
Replying to
@bronze@pl.kitsunemimi.club @D00B@clew.lol >vtubers
>looks inside
>its piss again.
many such cases.
Replying to on shortstacksran.ch
@sapphire@shortstacksran.ch @skylar@misskey.yandere.love @amperage1963@poa.st @EllisDee@wolfgirl.bar There are no USA made tools anymore (the last one was SK and they moved to china/vietnam in 2025)
Icon are the same tools as Snap-on. Quinn is the same product as Gearwrench/Duralast. Pittsburgh is the same as Craftsman/Husky/Hypertough/various amazon brands.
Replying to